The AvMaster Relay is the first and only self contained, fail-safe, avionics master relay package to protect expensive radio gear at an affordable price. The AvMaster Relay is installed between the power bus and the protected radios. The avionics master switch then controls the AvMaster Relay only and not the radios directly. Not only does the AvMaster Relay protect the system from transient electrical spikes during normal operations, its four parallel relay controlled circuits allow for individual fusing that separate all radios from each other. The fail-safe design of AvMaster Relay eliminates the need for a backup avionics master switch. If the avionics master switch ever fails, the pilot won't even realize it after the flight is over and the avionics master doesn't shut down the radio stack. The radios will just be controlled individually until the problem is resolved.
This board allows you to use any inexpensive switch [Single Pole, Double Throw, (ON)-OFF-(ON), Spring Loaded, 3 Position] to control your flap and elevator trim motors. You can series as many switches as you desire control your flap & elevator trim motors. Free connection diagrams for relay boards and airspeed switch for several typical systems. (Models: 1RY1, 2RY1, 3RY1)
The SuperSwitch™ is designed to replace all contactors on the aircraft with a wide variety of applications from master contactor through starter, external power, and alternator contactors.
The Ameri-ing AK-950R is a FAA TSO'd approved remote Relay Assembly. It is designed to provide Switching Function, for HSI/CKE Data inputs, between NAV(VOR) Receiver and the approached certified GPS receiver. The Assembly consists of a
The AN-21 is a light and warning tone generator for use in experimental aircraft. A total of twenty-one circuits can be monitored, sixteen channels are activated by ground and five by positive input.
3 Axis trim relay and buffer board has been designed to allow easy control of trim motors from small grip mounted or remote switches. Three Axis control is possible with each of the circuits being configured in a double throw format.
The HOT BOX is a complete electrical system intended for use with an electric starter equipped engine. The box contains a heavy duty regulator, starter solenoid, custom length cables, labeled terminal strips, a fuse panel and many more features.